Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TIP:
Dark spots can occur on the interfaces if the LED separating mass is not observed (three LEDs in a
group result in the designated mass). These can be reduced by calculating the corresponding section
so that there are no dark spots or few striking sections (e.g. at the profile end).
master units can be shortened up to a length of one metre maximum, whereby the length which con-
tains the transformers must always be used.
Slave units can be shortened as required. when shortening the units it is vital to bear in mind that
the connections of the slave units are arranged in the middle, because the LEDs can be supplied only
through them.
Then cut the profile to the actual measurement and deburr if
necessary.
Protect the end of the LED strip with insulating adhesive tape
from short circuiting on the subsurface and bend it under the
profile. Check that the insulating tape does not produce any
shadowing of the light.
27
Werbung
