NMC WALLSTYL Montageanleitung Seite 24

24
EARTHInG
COnnECTIOn TO POwER SOURCE
The master unit is connected sideways with the 220V-230V power source with the help of the appro-
ved connection clamps (not part of the scope of supply) and the pre-installed connector (assembled
with connecting cable) during the course of the installation. The affixed LED strips must not be dama-
ged in the process. These should therefore be installed in the immediate vicinity of the power cable to
facilitate subsequent connections.
The earthing connections must be electrically connected by
means of the supplied earthing cables between all profile
elements in the sections.
The earthing cable must be connected to the power source in
parallel to the connection cable with the push-on connector.
2-4 mETRE COnnECTIOn:
Starting at the slave, connect the white connectors with the
white extension cable (210 cm, in the supplies of the slave
unit) and plug them together with the individual ends of the
triple power socket (in the supplies of the slave unit). Run the
cable carefully between the clamps.
Attention: The clams may have sharp edges: risk of injury.
The triple power socket is then connected with the two white
sockets of the slave.
The master unit is connected to the 220V-230V power source
through the pre-installed connector and the connector cable
(in the supplies of the master unit).