NMC WALLSTYL Montageanleitung Seite 28

28
wALL mOUnTInG
The master and slave units are mounted on the wall magneti-
cally to guarantee reversibility.
Détachez le film de protection des aimants, puis collez-les
Affix magnets in the aluminium profile each time at the ends
and in the middle of the unit in the bottom height area after
removing the protective film. If necessary, affix the magnets
so that the magnetic force guarantees the mounting of the
LED baseboard in spite of the unevenness.
Additional mechanical fixing may be required if the walls are
not straight.
Position steel strip section on the magnets and remove the
protective film. Pay attention to the cable and other built-in
electronic components. Only flat steel strip sections flush with
the aluminium profile guarantee optimal adhesion.
Affix the aluminium profile on the wall next, with due care for
the marked baseboard height flush and by pressing at the
points of the steel strip sections.
TIP:
For stability purposes, cut three Styropor blocks supplied at
the corresponding height and apply them under the alumini-
um profile for support.