NMC WALLSTYL Montageanleitung Seite 29

AFFIxInG THE PmmA COVER
ADJUSTmEnT AnD AFFIxInG OF THE BASEBAORD
The PPmA cover is used to protect the LEDs and guarantees
a homogenous light distribution. Let the cover snap in the
profile above the LEDs. The cover should overlap the profile
transitions. A compound saw or a hacksaw is recommended
for cutting the PmmA.
The baseboards are adjusted as indicated in the installation
instructions for wALLSTYL® baseboards.
www.nmcdecoration.com -> downloads
Cut the wALLSTYL® baseboard so that the ends of the over-
lapping aluminium profiles are covered.
Clamp the adhesive cartridge of the assembly adhesive
ADEFIx® PLUS, and cut the cartridge nozzle (diameter: 5-8 mm).
Apply the wALLSTYL® baseboard on the rear adhesive side
as an unbroken strip (caterpillar).
Position the board and apply flush with the aluminium profile
with pushing motion.
29
ADEFIX® PLUS