NMC WALLSTYL Montageanleitung Seite 23

TIP
The wALLSTYL® LED light baseboard is designed specially for the following models of the baseboard range:
FB1 FD2
FB2 FD3
FD1 FD7
PREPARATIOn
ELECTRICAL COnnECTIOn
master – slave system
FD11 FD21
FD15 FD22
FD20 FL1
measure the length of the walls to determine the number of
master and slave units needed (see electrical connections).
Check the straightness and surface condition of the walls. The
reversible magnetic installation functions optimally on straight
walls. If the walls are not straight, an additional mechanical
fastening may be necessary. The following types of surface
are suitable: wallpapered, uncoated and plaster surfaces.
The surfaces must be clean, dry, dust- and fat-free and even
(if necessary, sand and clean).
mark the height of the baseboard on the wall with a pencil.
The wallstyl® light baseboards have two different basic units.
1. master unit with two build-in transformers
(Item no. mASTER 3015301)
2. Slave unit without transformers
(Item no. SLAVE 3015302)
The right number of master and slave units is to be selected
according to the section length:
• Sections of 1-2 metres: are provided with one master only
• Sections of 2 - 4 metres: 1x master + 1x slave unit
• Sections of 4 - 6 metres: 1x master + 2x slave units
• Sections > 6 metres: require the following units: master-
slave-slave.
Each master unit can supply another two slave units. To that
end, there are two connection possibilities available from
both transformers in the master unit. In essence, each power
supply of the master can supply 3 metres of LED strips
or 30 w maximum.
FL2 FL9
FL4 FO1
FL5 FO2
23