Herunterladen Inhalt Inhalt Diese Seite drucken

Conrad ATA-100 Bedienungsanleitung Seite 10

Controller
Inhaltsverzeichnis

Werbung

1. Kentekenen
• Insteekkaart voor PCI-Slot, PnP
• Twee IDE-controllers elk voor 2 vaste schijven, in totaal dus 4
IDE-toestellen aansluitbaar
• Werking ook bij grote schijven van meer dan 32GByte mogelijk
• Ideaal voor Ultra-ATA-100-toestellen (ook UDMA/100 of eender
genoemd, ook oudere IDE-toestellenzonder Ultra-ATA-100 kun-
nen worden gebruikt)
• Eigen BIOS
• Opstartbaar (afhankelijk van computer-Bios, of starten van het
besturingssysteem ("Opstarten") over de controller mogelijk is)
2. Leveringsomvang
• Insteekkaart
• Speciaal 80polig IDE-kabel (voor ultra-ATA-66 en ultra-ATA-100)
• Aansturings-CD
• Nl. gebruiksinstructie
3. Veiligheidsopmerkingen
Bij schade die door de niet-naleving van deze
gebruiksinstructie worden veroorzaakt, vervalt de
garantie.
Voor schade die daaruit voortvloeit, aanvaarden wij
geen enkele aansprakelijkheid!
Het product heeft scherpe kanten en uitstekende onderdelen – bij
aanraking bestaat gevaar voor letsels. Het product buiten het bereik
van kinderen houden.
50
When touching, assembling/dissembling appropriate safety measu-
res must be taken against static charging (e.g. earthing strip, non-
conducting surface etc.).
Handle the plug-in card with care. It can be damaged by impacts or
concussion or if being dropped form low heights already.
4. Configuration
J1: Primary IDE
If the controller is to accomplish the booting (depends on computer
BIOS), the first hard disk must be connected here. Two devices at
maximum (master & slave) can be connected here.
J2 Secondary IDE
Secondary IDE controller, two further devices (master & slave) can
be connected here.
J4: HDD-LED
This bipolar connection enables an LED of your PC's housing to be
plugged in. If the LED does not light when the hard disks connected
19

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis