Antenna Setting - Megasat Classic Line 19 Bedienungsanleitung

7. The Main Menu
Transponder
Delete (RED button)
Edit (GREEN button)
New (YELLOW button)
Search (BLUE button)
Note:
As new Channels are available, but these are not located in your TV list, proceed as
follows:
1. Find out the frequency of the new channel (e. g. on „www.satindex.de").
2. Go to the main menu Channel -> Dish Setup.
3. Select the satellite (e. g. Astra 19.2E) and click OK.
4. Now select the transponder from the list (e. g. 12.188 H 27.500) and click OK to
confirm.
5. Press the BLUE button to start searching on this Transonder.

Antenna setting

LNB type
LNB power
22 KHz
Toneburst
DiSEqC 1.0
DiSEqC 1.1
Motor
Note: Usually you have to make no changes in the antenna settings. It is recom-
mended that only experienced users change settings.
Deletes the selected transponder. Confirm the
irrevocable deletion by clicking OK.
To change the frequency, the symbol rate and the
polarity of the selected transponder. Confirm with OK.
Add a new transponder. Enter the frequency, symbol
rate and polarity of the new transponder.
Confirm with OK.
Start the search with the selected transponder. Select
the search mode, the transmitter and the service type.
Confirm with OK.
Change the LNB type
Change the LNB power supply.
Set the 22 KHz on or off.
Select between No, Burst A and Burst B
Select between No, LNB 1 to LNB 4
Select between No, LNB 1 to LNB 16
Select between No, DiSEqC 1.2 or 1.3 (USALS)
ENGLISH
15