Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Device 3
Starting address 25
MIC
MENU UP DOWN ENTER
+5V D- D+ GND
SAFETY EYELET
1: Ground
2: Signal (–)
3: Signal (+)
T1A/250V
POWER IN
POWER OUT
120 Ohms
Wireless DMX transmission with QuickDMX
The device features an alternative DMX input for a QuickDMX receiver (sold separately). This connector
allows for wireless transmission of DMX control signals to the device. The connector is designed as a USB
port which provides the required 5 V operating voltage for the receiver. With QuickDMX devices, extensive
cabling between the DMX controller and the bar is not required.
Occupation of the USB port:
Connection to the mains
The device uses an auto-range power supply that accepts input voltages between 100 und 240 volts.
1
Connect the device via the enclosed mains cable to a grounded mains socket. Thus the unit is switched
on.
2
To switch off the unit, disconnect the power plug.
3
Do not connect the unit to the mains voltage via a dimmer. For a more convenient operation, use a mains
outlet which is switchable.
Power supply of further devices
The jack POWER OUT allows for power supply of further devices. To interconnect several devices, connect
the jack POWER OUT to the input POWER IN of the next unit until all units are connected. Matching power
cables with P-Con plugs are available as accessories. In this manner, up to 8 devices can be linked at
230/240 input voltage and up to 4 devices at 110/115 input voltage.
Device 2
Starting address 13
MIC
MENU UP DOWN ENTER
+5V D- D+ GND
SAFETY EYELET
1: Ground
2: Signal (–)
3: Signal (+)
T1A/250V
POWER IN
POWER OUT
23/32
Device 1
Starting address 1
MIC
MENU UP DOWN ENTER
+5V D- D+ GND
SAFETY EYELET
1: Ground
2: Signal (–)
3: Signal (+)
T1A/250V
POWER IN
POWER OUT
DMX-512 Controller
00117153.DOCX, Version 1.0
Werbung
