Herunterladen Diese Seite drucken

Petsafe 100 m Schnellstartanleitung Seite 6

Vorschau ausblenden Andere Handbücher für 100 m:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 43
Fit the Training Collar
Important: The proper fit and placement of the training collar is important for effective operation.
The contact points must have direct contact with your dog's skin on the underside of his neck.
1. Start with the collar turned off and your dog standing comfortably, not sitting (A).
2. Place the collar on your pet so that the PetSafe
directly under your dog's chin. Centre the contact points underneath your dog's neck,
touching the skin (B). Note: It is sometimes necessary to trim the hair around the contact
points to make sure that contact is consistent.
3. Check the tightness of the collar by inserting one finger
between the end of a contact point and your dog's neck
(C). The fit should be snug but not constricting.
4. Allow your dog to wear the collar for several minutes, then
recheck the fit. Check the fit again as your dog becomes
more comfortable with the collar.
Find the Best Stimulation Level for Your Pet
Important: Always start at the lowest level and work upward.
The Remote Trainer has 1 tone, 1 vibration, and 15 static stimulation levels. This allows you to choose the
stimulation level that is best for your pet. We recommend training with tone and vibration, or the lower levels
of static stimulation when needed. In most cases static stimulation levels 1–7 will be adequate for your training
needs. Levels 8–15 are locked as a reminder that you are moving to higher static stimulation levels.
Once you have placed the training collar on your pet, it is time to find the "recognition level". The "recognition
level" is the static stimulation level that your dog begins to notice. It should not make your pet uncomfortable.
YOUR PET SHOULD NOT VOCALIZE OR PANIC WHEN RECEIVING STATIC STIMULATION. IF THIS
HAPPENS, THE STIMULATION IS TOO HIGH AND YOU NEED TO GO BACK TO THE PREVIOUS LEVEL.
Follow the steps below to find your pet's recognition level:
1. Choose level 0, and press the upper right button continuously for 1 to 2 seconds.
6
Do not shave the pet's neck as this may increase the risk of skin
irritation. The collar should not be worn for more than 12 hours out of
every 24-hour period. Leaving the collar on too long could lead to
skin irritation.
logo is facing forward and the collar is
®
B
petsafe.com
A
C

Werbung

loading

Diese Anleitung auch für:

300 m600 m900 m