Petsafe 100 m Schnellstartanleitung Seite 4

Charge the Training Collar and Remote
Important: Excessive charging can shorten battery life. Only charge the remote or collar when the
batteries are low.
1. Plug in and fully charge the remote and training collar. This can take up to 5 hours.
2. When fully charged, the green LED on the collar will turn off, and the battery meter on the remote will stop
cycling and appear full.
3. When the collar and remote are charged, replace their rubber covers.
To Turn the Training Collar On
Press and hold the on/off button until you hear a low to high beep and the
green LED appears, and then release.
Note: The remote is always on, and the display will appear when any button
is pressed.
To Turn the Training Collar Off
Press and hold the on/off button until the collar beeps high to low, and then
release. The red LED will be illuminated during the button press and will turn off
when the collar turns off.
Tip: When you're not using the collar, you should turn it off to preserve
the battery life.
Test the Remote Trainer
We recommend you experience firsthand how the static stimulation functions. Always begin at the lowest level,
and increase the intensity up to your personal comfort level.
1. Place one finger over both contact points of the training collar.
2. Hold your remote approximately 0.5 M from the training collar. Starting at level 0, press the vibration
button continuously for 1 to 2 seconds. You should feel continuous vibration. There is only one level of
vibration.
3. Increase the level to 1 for static stimulation. At this level you may not feel the stimulation.
Note: Continuous stimulation will transmit for no more than 10 continuous seconds. To reactivate, release and
repress the button.
4. Increase the level until the sensation begins to feel uncomfortable.
4
petsafe.com
On/Off
Charging
Button
Port