Kindermann CablePort flex Montage- Und Bedienungsanleitung Seite 12

3.1.4. Installation in the table cut-out
1
2
3
2
Screw the 4 mounting plates
Adjust the holding angles
4
loosen the 4 panhead screws with spring discs
screws accordingly.
6
Insert the basic module from below between the fastening bolts of the flat frame.
Caution: Do not pull the moving cable flap from above to keep it from bending.
Attach the two holding angles
with washer; not enclosed). Now pull the basic module over the 4 adjustment screws
flat frame, so that the heights of the flaps are precisely aligned with the flat frame.
Caution: Do not over-tighten the adjustment screws
Tighten all screws well .
5
3.1.5. Table cut-out for frameless, flush Installation
For frameless, flush installation, we recommend using a CNC machine
when producing the table.
The corresponding drawings and the DXF files for
CNC programming can be found in the download area of the
respective basic modules, http://shop.kindermann.com
Since part of the cut-out edge remains visible after the module has
been installed as well, an additional processing of the edges is
recommended.
CablePort flex
Basic module 4-fold
7448 000 030
Basic module 6-fold
7448 000 040
4
6
7
on with matching screws (not enclosed).
2
at the basics module approximately to the tabletop thickness minus 2–3 mm at the basic module,
slightly for this and adjust the two holding angles
5
to the tabletop from below with at least 3 suitable screws each (e. g. Ø 3.5 or Ø 4 mm, possibly
4
to keep the flat frame from bending.
6
Tischausschnitt X
According to plan
Tolerance +2/10 mm
According to plan
Tolerance +2/10 mm
First insert the flat frame
Attach the flat frame to the table section from below as
sketched with the enclosed 4 mounting plates
screws M3 x 25 or M3 x 40 (depending on tabletop thick-
7
ness), using the respective washers
5
evenly and only hand-tight towards the
6
Tischausschnitt Y
According to plan
Tolerance +2/10 mm
According to plan
Tolerance +2/10 mm
into the cut-out.
1
, 4 threaded
2
and nuts .
8 9
8
2
9
7
and the 4 adjustment
4
Tischplattenstärke Z
15 - 40 mm
15 - 40 mm
5