AKG MicroMic III Serie Bedienungsanleitung Seite 26

3 Using Your Microphone
Fig. 7: Double-
sided adhesive
rubber plate.
b) Mounting the H 416 on a flat surface without
Refer to fig. 7.
using screws:
• Remove the backing paper from both sides of
the rubber plate and press the rubber plate
firmly on the H 416 and then on the instrument
or speaker.
c) Mounting the H 416 on an uneven surface
without using screws:
• Use the supplied adhesive putty instead of the
rubber plate.
Both the rubber plate and the elastic putty pro-
Note:
vide the same amount of mechanical-noise at-
tenuation as the rubber eyelets on the H 416.
Fig. 8: Sliding the
microphone into
the H 416.
Refer to fig. 8. 2. Slide the bracket on the gooseneck into the
H 416 installation plate to the point that the
bracket audibly clicks into place.
You can remove the microphone easily, for in-
26