Avdel 74200 Betriebsanleitung Seite 30

S e r v i c i n g t h e To o l
Regular servicing should be carried out and a comprehensive inspection performed annually or every 500,000 cycles, whichever is sooner.
The employer is responsible for ensuring that tool maintenance instructions are given to the appropriate personnel.
The operator should not be involved in maintenance or repair of the tool unless properly trained.
D a i l y
•
Daily, before use or when first putting the tool into service, pour a few drops of clean, light lubricating oil into the air inlet of the tool if no
lubricator is fitted on air supply. If the tool is in continuous use, the air hose should be disconnected from the main air supply and the tool
lubricated every two to three hours.
•
Check for air leaks. If damaged, hoses and couplings should be replaced by new items.
•
If there is no filter on the pressure regulator, bleed the air line to clear it of accumulated dirt or water before connecting air hose to tool.
•
Check that the nose assembly is correct.
•
Check the stroke of the tool is adequate to place selected insert. (See stroke adjustment page 7).
•
Inspect the drive screw in the nose assembly for wear or damage. If any, renew.
We e k l y
•
Check for oil leaks and air leaks on air supply hose and fittings.
M o l y k o t e 5 5 m S a f e t y D a t a
Grease can be ordered as a single item, the part number is shown in the service kit page 11.
First Aid
SKIN: Wipe off and wash with soap and water.
INGESTION: No adverse effects are normally expected.
Treat symptomatically.
EYES: Irritant but not harmful. Irrigate with water and seek medical attention.
Environment
Scrape up for incinerating or disposal on approved site.
Fire
FLASH POINT: 101°C
Not classified as flammable.
Suitable extinguishing media: Carbon dioxide, foam, dry powder or fine water spray.
Handling
Plastic or rubber gloves should be worn.
Storage
Away from heat and oxidising agent.
10
I M P O R T A N T