Avdel 74200 Betriebsanleitung Seite 24

S a f e t y R u l e s
This instruction manual must be read with particular attention to the following safety rules, by any person
installing, operating, or servicing this tool.
1 Do not use outside the design intent.
2 Do not use equipment with this tool/machine other than that recommended and supplied by Avdel UK Limited.
3 Any modification undertaken by the customer to the tool/machine, nose assemblies, accessories or any equipment supplied by
Avdel UK Limited or their representatives, shall be the customer's entire responsibility. Avdel UK Limited will be pleased to advise
upon any proposed modification.
4 The tool/machine must be maintained in a safe working condition at all times and examined at regular intervals for damage and
function by trained competent personnel. Any dismantling procedure shall be undertaken only by personnel trained in Avdel UK
Limited procedures. Do not dismantle this tool/machine without prior reference to the maintenance instructions. Please contact
Avdel UK Limited with your training requirements.
5 The tool/machine shall at all times be operated in accordance with relevant Health and Safety legislation. In the U.K. the "Health
and Safety at Work etc. Act 1974" applies. Any question regarding the correct operation of the tool/machine and operator safety
should be directed to Avdel UK Limited.
6 The precautions to be observed when using this tool/machine must be explained by the customer to all operators.
7 Always disconnect the airline from the tool/machine inlet before attempting to adjust, fit or remove a nose assembly.
8 Do not operate a tool/machine that is directed towards any person(s) or the operator.
9 Always adopt a firm footing or a stable position before operating the tool/machine.
10 Ensure that vent holes do not become blocked or covered and that hoses are always in good condition.
11 The operating pressure shall not exceed 7 bar (100 lbf/in
12 Do not operate the tool without full nose equipment, oil plug and oil bleed screw in place.
13 When using the tool, the wearing of safety glasses is required both by the operator and others in the vicinity to protect against pin
ejection, should a fastener be placed 'in air'. We recommend wearing gloves if there are sharp edges or corners on the
application.
14 Take care to avoid entanglement of loose clothes, ties, long hair, cleaning rags etc. in the moving parts of the tool which should
be kept dry and clean for best possible grip.
15 When carrying the tool from place to place keep hands away from the trigger/lever to avoid inadvertent start up.
16 Excessive contact with hydraulic oil should be avoided. To minimise the possibility of rashes, care should be taken to wash
thoroughly.
4
2 ).