Camille Bauer SINEAX I 538 Betriebsanleitung Seite 10

6. Commissioning and maintenance
Switch on the power supply and the measuring input.
No maintenance is required.
7. Releasing the transducer
Release the transducer from a top-hat rail as shown in
Fig. 7.
Fig. 7
8. Instruments admissions
Germanischer Lloyd
Type approval certifi cate: 12 259-98 HH
CSA approved for USA and Canada
fi le-nr. 204767
10
9. Dimensional drawing
112.5
114.1
Fig. 8. Housing type P8/35 onto a top-hat rail (35 ×15 mm or
35 ×7.5 mm) acc. to EN 50 022.
FCC Compliance and Canadian DOC Statement
This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to both part
15 of the FCC Rules and the radio interference regulations
of the Canadian Department of Communications: These
limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may
cause harmful interference to radio communications.
Operation of this equipment in a residential area is like to
cause harmful interference in which case the user will be
required to correct the interference at his own expense.
5 6 7 8
1 2 3 4
35