Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2. Layout (Fig. 1)
1. Charger
2. Charging cable
3. Power plug
3. Technical data
Charger
Input .............................................12 V d.c.; 5.8 A
Output ........................................... 21 V d.c., 3 A
Caution!
The charging unit is allowed to be used only for
the lithium-ion batteries of the Power-X-Change
series!
4. Operation (Fig. 1-3)
1. Pull the battery pack (a) out of the handle,
pressing the pushlock button (b) as you do
so.
2. Insert the power plug (3) into your vehicle's 12
V socket. Check that it is fi rm and secure. The
green LED will begin to blink.
3. Insert the battery pack (a) into the battery
charger (1).
4. In section 7 „Charger indicator" you will fi nd a
table with an explanation of the LED indicator
on the charger.
If the battery fails to charge, please check the
following:
•
Is there enough voltage at the vehicle's 12 V
socket?
It must lie between 11.5 V and 16 V.
At voltages below 11.5 V the rechargeable
battery will no longer be charged in order to
protect the vehicle's battery.
At voltages below 10.5 V the charger will be
switched off completely in order to protect the
vehicle's battery from further discharge.
Caution!
In both cases take immediate steps to increa-
se the voltage of the vehicle's battery, e.g. by
starting up the vehicle's engine.
•
Is there good contact at the charging contacts
on the battery charger?
GB
If the battery still fails to charge, send
•
•
to our customer service center.
To ensure that items are properly packaged
and delivered when you send them to us,
please contact our customer service or the
point of sale at which the equipment was
purchased.
When shipping or disposing of batteries and
cordless tools, always ensure that they are
packed individually in plastic bags to prevent
short circuits and fi res.
To ensure that the battery pack provides long ser-
vice, you should take care to recharge it promptly.
You must recharge the battery pack when you
notice that the performance of the device drops.
Never allow the battery pack to become fully di-
scharged. This will cause it to develop a defect.
Mounting the charging unit on a wall (Fig. 4)
The charging unit can also be mounted on a wall.
The correct dimensions for drilling holes in the
wall can be found on the back of the charging unit.
Spacing distances
≥ 10 cm from the wall (right + left)
≥ 100 cm from the ceiling
≤ 200 cm from the fl oor
Caution!
When mounting on a wall you must use suitable
screws, e.g. 3.5 mm pan-head screws, in order to
prevent damage to the housing and risk of falling.
5. Cleaning and maintenance
Always pull out the power plug before starting any
cleaning work.
The equipment is not allowed to be stored in a
damp location or where there are caustic gases.
Keep it in a dry place out of the reach of children.
5.1 Cleaning
Keep the surface of the equipment clean and
wipe it only with a dry cloth.
- 12 -
www.sidirika-nikolaidi.gr
the charging unit
and the rechargeable battery
Werbung
