Meter Memory; Viewing The Test Results; Viewing The Average Of Blood Sugar Results Over A Number Of Days - Diatesse Xper Handbuch

NOTE:
• Do not press the puncture point against the
test strip and try not to smear the blood.
• If you do not apply a blood sample to the test
strip within 3 minutes the device switches off
automatically. Should this happen, remove the
test strip and re-insert it in order to start a new
test.
• The control window must be filled with blood
before the meter automatically starts to
countdown. DO NOT try to add more blood to
the test strip once the blood drop has filled the
control window. Should that happen, dispose
of the test strip, insert a new test strip and
repeat the test.
• If you struggle to fill the control window,
please contact your healthcare professional or
customer support for assistance.
5. Reading the test results
Your test results will appear once the meter
reaches 0 in its countdown. The result is
automatically stored in the meter.
6. Eject the used test strip (k)
Eject the test strip by pressing the ejector
button on the side of the device. Use a specially
designated waste container for disposing of
the used test strips. The meter switches off
automatically.
Always follow the instructions on the lancing
device's package insert for disposing of the
used lancet.
WARNING:
Used test strips and lancets could pose a
biological hazard. Dispose of them properly in
accordance with the local regulations.

METER MEMORY

The meter stores the 1,000 most recent test results
together with their dates and times. In order
to access these records, start with the device
turned off.

Viewing the test results

1. Press and release the button marked M.
" " will appear on the display. Press M again,
the first measurement displayed is the
most recent one, together with the date, time
and meter mode.
2. Press M to call up the results stored in the
meter. If you keep the M button depressed, the
meter will switch off.
Viewing the average of blood
sugar results over a number of
days
1. Press the button marked M (and keep it
depressed for a few seconds) then release it to
open the memory mode and to view the average
results with " " and " DAY AVG " on the
display. Release the M button and the average
results over 7 days will appear on the display
with the meter in General mode.
2. Press M to view the average results over 14, 21,
28, 60 and 90 days. These results are stored in
each meter mode under Gen, AC and finally PC.
3. To shut down the meter's memory. Press the M
button repeatedly; the meter switches off after
displaying the most recent test results.
9