Madeira Toletum Bedienungsanleitung Seite 53

1
Switch off the circuit breaker
of the installation site.
4
Install the ceiling bracket with
the screw kit. Make sure the
ceiling bracket is securely fas-
tened.
7
Slide the remote unit into the
ceiling bracket as shown.
10
Install the cover 2 of the fan
unit 5 by attaching it to the
ceiling bracket and reinstall
the screws removed in step 2.
13
Fit lamps (E27 / max. 46 W /
not included) to the two sock-
ets of the luminaire base 4.
2
Remove the right screw of the
ceiling bracket screws 6 on
both sides. Keep them for step
10.
WARNING! Wall anchors must fit the ceiling type, the
weight of the fan, and its torque.
5
Connect the cable to the termi-
nal as follows:
L Brown
N Blue
Yellow/Green
8
Install the RF receiver of the
remote unit at its opening on
the cover 2.
11
Install the five blades 1 to the
motor of the fan unit 5 by use
of three screws per blade.
14
Install the luminaire cover 3
and check it for secure fitting.
ENGLISH
3
At the installation site, fix ade-
quate wall anchors (not includ-
ed) to the ceiling.
6
Hang the fan unit 5 into the
ceiling bracket. Rotate the fan
unit 5 until the rotation latch
engages.
9
Connect the two cable clips of
the remote unit with the cor-
responding clips on the fan
unit 5.
12
Connect the cable clip of the
fan unit 5 with the clip on the
luminaire base 4 and install
the luminaire base 4 to the fan
unit 5 using its three screws.
15
Switch on the circuit breaker
of the installation site.
GB
53