Madeira Emvatis Bedienungsanleitung Seite 53

1
Switch off the circuit breaker
of the installation site.
4
Install the ceiling bracket with
the screw kit. Make sure the
ceiling bracket is securely
fastened.
7
Connect the cable clip of the
ceiling bracket with the clip of
the fan unit 2.
10
Install the four blades 3 to
the blade holders 6 by use
of three screws, washers,
spring-washers and nuts per
blade.
13
Install the two pull chains at
the speed and light switch of
the fan unit 2.
2
Remove the right screw of the
ceiling bracket screws 5 on
both sides.
5
Connect the cable to the ter-
minal as follows:
L Brown
N Blue
Yellow/Green
8
Install the cover 1 of the fan
unit 2 by attaching it to the
ceiling bracket and reinstall
the screws removed in step 2.
11
Fit a lamp (max. 60 W / not
included) to the socket of the
fan unit 2.
14
Switch on the circuit breaker
of the installation site.
ENGLISH
3
At the installation site, drill two
8 mm holes into the ceiling and
insert the wall anchors (not in-
cluded).
6
Hang the fan unit 2 into the
ceiling bracket. Rotate the fan
unit 2 until the rotation latch
engages.
9
Install the four blade holders 6
to the motor of the fan unit 2
by use of two screws per blade
holder.
12
Install the luminaire cover 4 by
carefully tightening the three
screws of the fan unit 2 and
check it for secure fitting.
GB
53