What.to.do.if; General.conformity.declaration - Becker Centronic Sensorcontrol Sc861 Bedienungsanleitung

Problem
Drive.is.not.functioning..
Transmission.control.
light.is.on.
Drive.is.not.running.,.
LED.is.not.illuminated.
Automatic.control.com-
mands.are.not.carried.
out.
The.system.does.not.au-
tomatically.extend.when.
should.the.sliding.switch.
be.set.to."S".
The.system.does.not.
extend.in.response.to.a.
manual.command.when.
the.sliding.switch.is.set.
to."H".or."S".
General conformity declaration
Becker-Antriebe.GmbH.hereby.declares.that.the.device.Centronic.SensorCon-
trol.SC861.complies.with.the.basic.requirements.and.other.relevant.regulations.
of.the.EC.Directive.R&TTE.1999/5/EC.
For.use.in.the.following.countries:.EU,.CH
Subject.to.technical.changes.without.notice.
What to do if ...?
Cause
1..Receiver.is.outside.
of.the.radio.operating.
range.
..The.SC861.has.not.
been.programmed.into.
the.receiver.
Energy.storage.is.
empty.
The.sliding.switch.of.the.
hand-held/wall.trans-
mitter.is.set.to.manual.
mode."H".
1..The.sunlight.thresh-
old.value.has.not.been.
reached.
..The.wind.thresh-
old.value.is.has.been.
exceeded.
The.wind.threshold.
value.of.the.transmitter.
has.been.exceeded.
Remedy
1..Reduce.the.distance.
to.the.receiver.
..Programme.the.
SC861.
SC861.has.to.be.char-
ged.by.sunlight.
Adjust.the.sliding.switch.
of.the.hand-held/wall.
transmitter.to.automatic.
mode."S".
1..Adjust.sunlight.
threshold.value.using.
the.transmitter.
..Wait.until.wind.
abates.
Wait.until.wind.abates.
DE
GB
FR
NL
15