Herunterladen Diese Seite drucken

Mission Air HYDRO FLOW 3,3 KW DARK Betriebs Und Installationsanleitung Seite 19

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

  • DEUTSCH, seite 33
I M P O R T A N T S A F E T Y I N S T R U C T I O N S
1.
For your satisfaction and safety, read all instructions before installing or using this instant
hot water tap.
2.
This particular unit is not intendedfor commercial use.
3.
This appliance should be connected to mains water feed.
4.
This appliance can be used by children aged from 3 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge if they
have been given supervision or instruction concerning use of the appliance in a safe way
and understand the hazards involved. Childrenshall not play with the appliance. Cleaning
and user maintenance shall not be made by children without supervision.
5.
Make sure that all electrical wiring, plug and connections confirm to local codes. Means for
disconnection must be incorporated in the fixed wiring in accordance with the wiring rules.
This appliance must be installed in accordance with the national wiring regulations.
6.
If you suspect there is too much chlorine in your water, it is recommendedto use a water
filtration system.
7.
This applianceis forbiddento be switched on hot water if you think itmay be frozen. Wait
until you are sure that it has completely thawed out before you switch it on .
8.
This appliance is forbidden to be switched on hot water without inlet water supply
9.
Filter screen is required to be fixed at the water inlet. filter screen should be
regularlycleared. The outlet nozzle must be descaledregularly.
10.
Rated pressure of the tap is O Pa, the gate of water inlet & outlet mustn't be blocked. The
out-let must not be connected to any tap or fittingother than those specified.
11.
In cold winter, if the hot water temperature is not hot enough, the hand shank can be
adjusted the water flow to increase or decrease the hot watertemperature.
12.
All the appliances was processed water test and energization test before leaving factory , if
there is a little water at the waterinlet and water outlet while you use it for the first time, it is
a normal phenomenon, please feelat ease to use it.
13.
If there is damage to the wire, you must contact qualified electrician to replace it with
dedicated wire fromour authorized dealers.
missionair
T E L . ( + 4 8 ) 7 9 7 4 5 1 1 1 1
B I U R O @ M I S S I O N A I R . P L
S E R W I S @ M I S S I O N A I R . P L
EN
W W W . M I S S I O N A I R . P L
19

Werbung

loading

Diese Anleitung auch für:

Hydro flow 3,3 kw silver