CAME BPT TA/500 Montage- Und Betriebsanleitung Seite 36

Note. If the external probe is set as the main probe, the temperature it detects is shown on the display
and used as a reference for the operation of the heating/cooling system. The temperature detected by
the device's internal probe cannot be seen on the display.
Remote activation via phone (only on battery-powered model)
By connecting a suitable telephone interface to the terminals
for the Heating or
Activation - Close the contact
Deactivation - Close the contact
and the device goes back to the operating mode prior to activation. Deactivation can also be achieved by
manually changing the operating program.
Cooling modes, in the following ways:
for at least 5 seconds. The icon comes on on the display.
for at least 5 seconds. The
Use of terminals
(only on battery-powered model)
Choose the function associated with the termi-
nals using the
= compatible remote probe
= telephone contact
A
= window contact
Choice of main probe
(only on battery-powered model)
If you have chosen to connect to the termi-
nals
pressing the
in figure B appear.
Using the
B
the function that the external probe must
carry out:
= Secondary probe
= Main probe
you can activate the "Comfort" program
icon disappears from the display
If you have chosen to connect to the termi-
nals a suitable telephone interface
C ( ), pressing the
the screen in figure D.
C
arrows A from:
an external probe (
button will make the screen
arrows you can choose
button brings up
),