SYMA X440 Bedienungsanleitung Seite 9

3.0 Product Assembly
3.1 Propeller Installation
Detaching the propellers
Remove the propeller caps and screws in the
direction of the arrow, and then detach the
propellers.
Refer to the figure, install the label "A" propeller and label "B" propeller in the
corresponding positions, and use a screwdriver to tighten the screws.
Note:
!
1. Please make sure that the forward and reverse propellers are installed in the correct position. If the
installation is incorrect, the drone will not be able to fly normally.
2. Since the propeller is thin, please be careful when installing them to prevent accidental scratches.
3. Please use the propellers provided by our manufacturer.
4. The propellers are consumables, if necessary, please purchase additional accessories.
3.2 Propeller Guard Installation
Insert the guard into the arm in the direction of the arrow.
Installing the propellers
Place the propellers on the arm in the
direction of the arrow, tighten the screws
then place the propeller caps.
6