Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Level calibration
Place the drone on a flat surface and move the left
and right joysticks to the lower right corner for
approximately 3 seconds. The indicator will flash
rapidly and then turn solid to indicate that the
calibration process is complete.
The drone cannot be calibrated if the angle of
inclination is greater than 10 degrees.
Turning the drone on
Method one
Push the left joystick fully up
and return to the center. The
propeller will begin to rotate
slowly.
Turning the drone off
Method one
Push the left joystick downward
for 2-3 seconds to switch the
drone off.
Note:
!
1. The drone will switch off automatically if its angle of inclination exceeds 90 degrees.
2. If the drone is flown out of range from the remote control, the drone indicator light will start to
flash and the drone will land slowly.
3. If the remote control suddenly turns off or runs out of power during flight, the drone will
automatically land and come to a stop. If the remote control is turned back on during this process,
you will be able to control the aircraft again.
Method two
Push the left and right joysticks
downward in a V shape for 2
seconds. The propeller will
begin to rotate slowly.
Method two
Push the left and right joysticks
downward in a V shape for 2
seconds to switch the drone off.
Method three
Press the one key take-off/landing
button. The propeller will begin to
rotate slowly then the drone will
automatically take off and hover
at a fixed height.
Method three
Press the one key take-off/landing
button. The drone will slowly
descend to the ground and switch
off automatically.
10
Werbung
