Omnitronic FAS 2 Bedienungsanleitung Seite 26

► Auto scan
Auto scan mode (bodypack only) allows you to automatically set an
interference-free transmission channel. In this mode, too, simply press the
SET key briefly. The setting is immediately accepted by the receiver and the
reception indicators light up for confirmation.
► Change mode
To switch between fixed frequency selection and scan mode, press the on/off
switch on the bodypack transmitter for 3 seconds.
The CHARGE indicator shows the current mode at power up:
Fixed frequency
selection
Scan mode
The following options are available for switching off:
Keep mode
Change mode
Status
Flash 3 times
No flash
Status
Short press
Press 3 sec (new mode active when switching on
the next time)
26 • EN