Omnitronic FAS 2 Bedienungsanleitung Seite 24

Use
4
4.1 Setup
► Switching on
To switch on the receiver/bodypack/microphone, press and hold the
respective on/off switch. Switch the devices off again after use. Otherwise,
the (rechargeable) batteries are used up until the next operation. The
assignment of the transmitters to the receiver is kept memorized even after
disconnecting the power supply.
► Establish radio link with transmitter 1
Press and hold the SET key on the transmitter and set group A. The control
LED lights up blue. The receiver automatically accepts the setting, so that no
operation is necessary here. The left group/reception indicator on the receiver
lights up green as soon as the radio link between the devices is established.
► Establish radio link with transmitter 2
Press and hold the SET key on the transmitter and set group B. The control
LED lights up red. The receiver automatically accepts the setting here as well,
so that no operation is necessary. The right group/reception indicator on the
receiver also lights up green for confirmation.
Notes
• There are 40 channels divided into 2 groups available for radio
transmission. The channels are factory-set and non-adjustable. The
corresponding frequencies are given in the table in section 7.2.
• Please note that you can only use a maximum of 2 transmitters at a time.
Receivers can be used in parallel operation on the same radio frequency
as many as you like.
24 • EN