Scope Of Delivery; Product Overviews; Operation - Euromate 482300 Bedienungsanleitung

• Do not press the buttons on the control panel with
anything other than your fingers.
• Do not remove any fixed covers.
• Never use this appliance if it is not working prop-
erly, or if it has been dropped or damaged.
• Never use the plug to start and stop the unit.
• Do not cover or obstruct the inlet or outlet grilles.
• Do not use hazardous chemicals to clean or come
into contact with the unit.
• Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance.
• Avoid fire hazard or electric shock. Do not use an
extension cord or an adaptor plug. Do not remove
any prong from the power cord.
• Be sure the electrical service is adequate for the
model you have chosen. This information can be
found on the serial plate, which is located on the
side of the cabinet and behind the grille.
• The device must be used in a properly grounded
wall receptacle. If the wall receptacle you intend
to use is not adequately grounded or protected by
a time delay fuse or circuit breaker, have a quali-
fied electrician install the proper receptacle.
• Ensure the receptacle is accessible after the unit
installation.
• Remember that moving parts may also be located
behind ventilation and venting slots.
• If the power cord of this device is damaged, it
must be replaced by the manufacturer, its cus-
tomer service department or a similarly qualified
person, in order to avoid potential hazards.
• Use the appliance only on a flat surface.
• Do not use outdoors.
• The level of water tank should be not over max
scale at any time, when humidifying, the total level
of water tank should be min scale.
• After adding water to the water tank, do not title or
knock over the appliance when you put or move
it. If you want to move, please drive it at side, in
order to avoid spilling the water.
• Do no turnover the appliance. If it is toppled over,
and there have some water in the body, should
unplug the power supply. Then send it to repair
department or after-sales service and overhaul.
• Do not make air outlets and inlets near the wall or
curtain.
• Do not knock or shake the body when use, other-
wise it may cause stop.
• The water in water tank can easily metamorphose
and have at summer, renew the water frequently.
• Do not use the appliance in the immediate sur-
rounding of a bath, a show or a swimming pool.
• This product release mist. Do not place this
device directly on wood furniture, flooring or any
surface that could be damaged by water.
• Before filling or cleaning the unit, make sure it is
unplugged.
• Do not inhale the mist/vapor expelled from the
product or drink water from the tank.
• Do not fill the water tank with hot or boiling water.
• Do not keep water in the tank when not in use for
an extended period of time.
• Do not clean the unit, water tank or water reser-
voir with detergents or chemicals of any kind.
• Do not cover the spray spout at any time during
use. Do not put anything or in the tank.
• Important: Neither humans nor animals can hear
the high frequency vibrations.
• Symbols appearing on your device may not be
removed or covered. Signs on the device that are
no longer legible must be replaced immediately.
• Do not use the unit in the presence of inflammable
substances or vapour such as alcohol, insecti-
cides, petrol, etc.
Before putting the unit into operation, read
and observe the instructions for use.

Scope of delivery

Note: The actual appearance of your prod-
uct may differ from the illustrations.
• Mini air cooler
• USB cable
• Dropper bottle
• Operating instructions

Product overviews

► Overview – p. 2
1. Water tank
2. Outlet of diffuser
3. Fan
4. LED
5. Sterilize
6. Power button
7. Diffuser

Operation

Filling Water Tank
► P. 3, item 1
– Before turning on power, open top lid and remove
diffuser dropper bottle. Fill side tank with water.
Wait 3-5 minutes to allow filter to saturate, then
refill side tank.
– Single full tank lasts 3-5 hours depending on fan
speed and environment temperature.
Note: For faster result, remove cooling filter
and dip the filter into water for 1 minute then
re-fit it
Filling Diffuser
► P. 3, item 3
– To fill the oil diffuser tank (located on underside of
top lid), lift open top lid and remove rubber plug
from diffuser cartridge. Fill dropper bottle with
water and your favorite essential oils. Place tip of
dropper bottle into the diffuser cartridge and fill.
Power
– Plug machine into a USP power supply by USD
cable.
– Press the power button for 1 – 1.5 seconds to turn
ON. Press again for 1-1.5 seconds to turn OFF.
GB
17