Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Bedienungs- und Wartungsanleitung für Handschweißextruder Serie HSK18 RSX
8. Maintenance
General rules for all maintenance works:
During machine start-up, maintenance works as well as in continuous operation, the
appropriate directions of employer liability insurance association on the subject of
accident prevention must be strictly followed.
Please check the connecting cable regularly in view of eventual damage!
We do not accept any liability for damage to persons or machine parts occurred by
insufficient maintenance works or improper greasing.
Please take into consideration that regular and thorough maintenance will increase
the lifetime of your manual welding extruder and avoid unnecessary standstills during
production.
For all repairs at the electrical devices please refer to the high-voltage tests as per
VDE 0740.
8.1 Cleaning
After 100 service hours or after 3 months at the latest the cooling slots at the motor
housing must be cleaned and the motor blown out with dry compressed air.
8.2 Maintenance works
After 300 service hours or after 6 months at the latest the machine must be
thoroughly cleaned, all gear parts and ball bearings washed with solvents and
provided with fresh grease. The space between inner and outer ring of ball bearings
may only be filled with grease at 1/3 to prevent bearings running hot. Only use
special grease
After 150 service hours the thrust bearing (item no. 5) of the extruder screw must be
dismounted, cleaned and provided with fresh grease. For the lubrication of the thrust
bearing only use
30
HSK Kunststoff Schweißtechnik GmbH
Pull out mains plug!
Electrical parts to be cleaned without liquids!
Only use original spare parts!
brand FEIN, Type Sst.I.
MOLYKOTE "Montage und Einlaufpaste weiß"
Werbung
