Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Bedienungs- und Wartungsanleitung für Handschweißextruder Serie HSK18 RSX
HSK Kunststoff Schweißtechnik GmbH
4.2 Handling of manual welding extruder
First operation of the machine has to be done as per chapter 4.1. The manual
welding extruder may only be guided at the handles fixed to this purpose.
In order to avoid injuries by burning in case of unproper handling, the operator has to
wear heat-resisting gloves.
Further on all limbs of the operation staffs have to be covered by appropriate clothes.
If works have to be carried out over head or in narrow places (for ex. gully holes or
narrow receptacles), a second person has to be present as a matter of security.
Please note that a welding with satisfactory results requires a faultless welding wire,
a proper pre-heating and a perfect preparation of the welding.
Please make sure that the welding wire to be used is not too old and was stocked
properly.
Aside from sufficient air stream (see chapter 2) the quality of the procured air is
determinant for the quality of the welding.
You will obtain best welding results by using dry and dust free air.
The preparation of the welding will depend on the materials to be welded and the
welding geometry. For any information on the preparation of the welding please refer
to existing literature or to the corresponding directives in the branch.
Existing regulations which have been established for many branches (for ex. DVS
regulations) regarding the manufacture of plastic connections by welding have to be
strictly observed.
27
Werbung
