Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Bedienungs- und Wartungsanleitung für Handschweißextruder Serie HSK18 RSX
4.2 Start-up
Prior to the start-up of the machine it must be secured that the motor is cut off. If not,
the on-off switch of the drive must be unlocked.
Prior to heating up the manual welding extruder the handle this is delivered with the
machine, has to be mounted onto the cylinder.
Further on proceed with air supply of the air heater. The air heating unit needs dry
and dust free air as per the following specification:
After having procured the mains supply by connecting the plug, the heating of the
manual welding extruder is switched on automatically.
By this action there is the danger of injury by burning at the places marked with a
!
in the following picture:
Please see to it that in front of the air pre-heating nozzle there are no materials which
are easy inflammable or explosive.
Make sure that the set mass temperature (setting process see chapter 5.2) is
suitable for the material to be welded.
With HSK manual welding extruders equipped with electronic regulation of the mass
temperature, a minimum temperature of 180°C cannot be under run.
In special cases this figure can be changed after having contacted the manufacturer
or his authorized agents.
Prior to the feeding of the welding wire the drive has to be switched on.
The welding wire has to be fed with slight pressure. Once the machine has seized
the welding wire, the further intake is done automatically.
26
HSK Kunststoff Schweißtechnik GmbH
- Volume flow > 300 l/min.
- Air pressure absolute < 2bar.
Werbung
