Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Bedienungs- und Wartungsanleitung für Handschweißextruder Serie HSK18 RSX
5. Operating instructions for regulator Omron E5GN
D
ISPOSITION OF REGULATOR FRONT PLATE
8
7
1) Display No. 1, shows actual value
2) Operation indicators
CMW, STP, OUT
3) Display Nr. 2, shows rated value
4) Up and down keys.
Use the keys to vary the setting for the rated value. Each press on the „up"-key increments or
advances the values or settings. Each press on the „down"-key decrements or returns the values
or settings
5) Changes the contents of the display
6) Used to change levels.
7) Alarm / operation function
8) Temperature unit
For further information please refer to the regulators instruction manual.
5.1 Mounting of regulator
At first please disconnect the manual welding extruder from the electrical
network!
The regulator has to be inserted into the switchboard cut out from the front. Put the
fastening frame from the rear and press it against the rear side of the switchboard.
Afterwards insert the connector block into the regulator.
For taking the regulator out, first open the switch box.
Thereafter remove the contact strip. After removal of the fastening frame the
regulator can be taken out of the switch box.
28
HSK Kunststoff Schweißtechnik GmbH
:
O M R O N E 5 G N
° C
A L
6
Never press keys 5 and 6 at the same time
1
C M W
S T P
O U T
5
4
2
3
Werbung
