Volvo LOAD CARRIER FOR CARS WITHOUT RAILS Bedienungsanleitung Seite 5

To install the correct carrier in the correct
place, refer to the marking on the mounting
clamp which is located under the cover.
The mounting clamps are marked:
LF = left front
RF = right front
LR = left rear
RR = right rear
• Undo the bolts slightly on both sides of the
load carrier's clamp bracket.
• Pull the clamp bracket out and fold it up.
LOAD CARRIER FOR CARS WITHOUT RAILS
1
3
• Position one of the load carrier's feet (1) at
the edge of the roof, so that the pin (2) on
the clamp are in line with the rivet nut (3) in
the door frame.
• Carefully lower the other load carrier foot to
the edge of the roof on the other side.
• Check that the contour of the load carrier's
foot is placed in full contact with the roof
edge. It has to match the curvature of the
top side of the roof.
IMPORTANT
Be careful not to damage the car's
paintwork.
en-GB
2
5