Volvo LOAD CARRIER FOR CARS WITHOUT RAILS Bedienungsanleitung Seite 4

LOAD CARRIER FOR CARS WITHOUT RAILS
Introduction
en-GB
Follow the instructions carefully when
installing the load carriers.
NOTE
Read the safety instructions at the end of
this manual.
Installing the load carriers
Kit contents
4
Positioning the load carriers
Open the doors.
• Locate the mounting points for the load
carriers in the door frames. The mounting
points consist of a rivet nut that are
countersunk into the door frames.
IMPORTANT
To avoid paintwork damage:
Thoroughly clean the rivet nuts and the
roof where the clamps and feet for the
load carriers will make contact with the
paintwork.
• Loosen the cover on the load carriers by
turning the locking key 90° anticlockwise,
and then carefully loosen the cover.
• Remove the cover.