Sennheiser freeSound HiDyn plus RS 8 Bedienungsanleitung Seite 17

Putting the receiver into operation
Insert the BA 151 rechargeable accuplug into the battery compartment
Switching the headphone receiver on
Switch on the headphone receiver and adjust the volume with control
Adjusting the receiver channel
Transmitter and headphone receiver have to work on the same frequency:
Put the transmitter and the headphone receiver into operation as described above. Switch on the signal
source! If possible, switch off its loudspeakers.
Select a transmission channel (1, 2 or 3) on the transmitter with switch µ.
Adjust the volume control
Slowly turn control
noise should now stop and the LED
circuitry stabilises your adjustment.
Transmitter and headphone receiver are now operating on the same frequency.
Simultaneous operation of several systems
Your neighbour also likes listening to music with an RS 8? No problem! With switch µ, you simply select
a different channel on each transmitter. Then set the headphone receivers to the respective frequencies
(with control , as described above). Observe a minimum distance of 2 m between two transmitters.
on the headphone until you can hear a low hissing.
(" ") on the headphone until you can hear the audio signal loud and clear. Tuning
TUNE
should be lit. The receiver's AFC (Automatic Frequency Control)
on the headphone receiver.
.
17