EuroLite LED MLZ-56 TCL 36x3W Bedienungsanleitung Seite 21

Manual Zoom
Press the MODE button until the display shows "o-1".
You can select the desired Zoom degree via the UP or DOWN buttons.
Mode:
o-1
Sound Control / Sensitivity
Press the MODE button until the display shows "S.00". You can select the desired sensitivity via the UP or
DOWN buttons.
Mode:
S.00
Master /Slave
Set the Master device to one of the above mentioned modes and set each Slave device to the same DMX
address "001".
DMX MODE
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED MLZ-56 TCL 36x3W will respond to the controller.
Addressing
Press the MODE button until the display shows "001". You can now set the desired address via the UP or
DOWN buttons.
Setting the DMX Start Address:
Mode:
001 001 - 512
Controlling:
After having addressed the LED MLZ-56 TCL 36x3W, you may now start operating it via your lighting
controller.
Note:
It's necessary to insert the XLR termination plug with 120
proper transmission on the DMX data link.
Choosing a DMX Channel Mode with 4 or 6 Channal Occupation
The device has 2 DMX-modes. The Control Board allows you to assign the DMX-Mode.
Setting DMX Mode
After setting the desired address via the UP or DOWN buttons, press the MODE button again and the
display shows "4.CH".
In case you would rather select the 6-channel mode, press the DOWN button in order to choose the 6.CH
setting.
Mode:
Value:
o-1 - o-9
Value
S00 - S99
Value:
Value:
4-CH
6-CH
in the last lighting in the link in order to ensure
21/23 00068642.DOC, Version 1.0