Werbung
Control panel (1) / Remote control (9) buttons description:
A. Standby mode button
D. Temperature decrease button
Display panel (2) icons description:
A1. Cool air airflow icon
B1. + B2. Hot air heating icons
F1. Oscillation function icon
USAGE
1. Ensure the power switch (8) is off. Insert the plug into a suitable power outlet and turn the power supply on by pressing to position I the
power switch (8) located at the back of the device. The device is in standby mode.
2. Press button (A) on the control panel (1) that will respond to your touch, and the LED display (2) shows the room temperature (G). The
cool air is flowing and fan icon (A1) is shown too.
3. Press button (B) to control temperature of heating:
-
Once, to get warm airflow, the icon (B1) will be illuminated up.
- Twice, to get hot airflow, both of sun (B1 and B2) will be illuminated up.
- Third time, to come back to cool airflow.
4. Press button (C) repeatedly to set a period after which the device will turn itself off. Time range from 0 to 12 hours. When timer function
is active the icon (C1) is illuminated up on the display panel (2).
5. Press button (D) or (E) to control required room temperature. Temperature setting from 10 to 35 degree of Celsius. Press button (E) to
increase the desired temperature and button (D) to decrease the desired temperature. The temperature icon (G) indicates the current room
temperature, e.g. 21 degrees Celsius. After selecting the desired temperature in the room, e.g. 25 degrees Celsius, the display will flash
four times remembering the target temperature of 25 degrees Celsius, and then return to showing the current ambient temperature, i.e. 21
degrees Celsius, which will increase to 25 degrees over time.
The device control room temperature automatically according to below principle:
- when the room temperature lower 4 degree of Celsius than the settled temperature on the device, it's hot air heating power,
- when the room temperature lower 2 degree of Celsius than the settled temperature on the device, it's warm air heating power,
- if room temperature reach the setting temperature, the heating stop, the fan is permanently flowing cool air until the room temperature
lower than the setting temperature by 2 degree of Celsius. If it occurs the device automatically return to warm air heating power,
- if room temperature lower 4 degree of Celsius than the settled temperature on the device, it's automatically return to hot air heating.
6.Press button (F) to active oscillation function, the icon (F1) will be illuminated up at display panel (2), the device will swing the left side
and the right side in range of angle 60 degree. Press it again to cancel the oscillation function.
7. Press button (A) again, the icon (A1) is blinking the device will working 30-60 seconds with cool airflow to cool down inside components
before shutting down to standby. Such design protects the device lifetime.
8. Operation by remote control (9) is same as operation by button pressing on the control panel (1).
BATTERY ECHANGE PROCEDURE
Follow the instructions of use and the recycle rules given on the battery packaging. The procedure of battery replacement is described
below – look at figure 3.
1. Open the battery compartment by sliding the cover down.
2. Insert the battery into the compartment. The remote control requires 1 CR2025 3V lithium battery.
3. Close the battery compartment.
B. Heating level button
E. Temperature increase button
B1. Warm air heating icon
C1. Timer icon
G. Temperature icon
C. Timer button
F. Oscillation button
8
Werbung
