Herunterladen Diese Seite drucken

Tunze Comline Wavebox 6214 Gebrauchsanleitung Seite 14

Vorschau ausblenden Andere Handbücher für Comline Wavebox 6214:

Werbung

26
Platzwahl für Wavecontroller
Die Wand muss trocken, vor Spritzwasser und
Feuchtigkeit geschützt sein. Auf keinen Fall über
dem Aquarium! Gerät niemals mit nassen Fingern
berühren! Wenn z.B. Wasser auf die Foodtimer
Taste kommt, kann die Elektronik Schaden
nehmen! (1)
Kabellänge
der
Geräte
beachten,
denn
Verbindungskabel dürfen nicht verlängert werden.
Vorhandene
Fotozelle
im
Lichtkegel
Aquarienbeleuchtung platzieren (siehe Funktionen
des Wavecontrollers).
Die
Befestigung
des
Wavecontroller
den
beiliegenden
selbstklebenden
Kunststoff-
Hakenbändern vorgesehen.
Kabelanschlüsse so verlegen, dass kein Wasser
entlang laufen kann und in den Controller gelangt
(2)!
Location selection for the Wavecontroller
The wall has to be dry. It has to be protected against
splashed water and moisture. Never fit above the
aquarium ! Never touch the unit with wet fingers ! If
water enters the Foodtimer button, for example, the
electronics may be damaged (1).
Observe the cable length of the units because the
die
connecting cables must not be extended.
Place a photo-electric cell in the light beam of
der
the aquarium illumination (cf. Functions of the
Wavecontroller).
The Wavecontroller has to be attached with the self-
ist
mit
adhesive plastic hook and loop strip enclosed.
Fit the cables in such a way that water cannot run
along them and get into the controller (2)!
Placement du Wavecontroller
La surface de fixation doit être propre, protégée des
éclaboussures et de l'humidité, jamais au-dessus
de l'aquarium ! Ne pas manipuler le contrôleur
avec des doigts humides : destruction de la platine
électronique si de l'eau pénètre par le Foodtimer ! (1)
Lors de l'installation, la longueur des câbles doit
être prise en compte car les câbles ne peuvent subir
aucune prolongation.
Placez la cellule photo dans le cône de lumière de
l'éclairage (voir Fonctions du Wavecontroller)
La fixation de Wavecontroller s'effectue par des
bandes Velcro auto-collantes.
Positionnez les câbles de telle manière à ce que la
pénétration d'eau dans le boîtier soit impossible (2)!.
27

Werbung

loading

Diese Anleitung auch für:

Comline wavebox 6208