LG WH20S F5 Betriebsanleitung Seite 19

Connecting the Water Supply
NOTE
• DO NOT directly solder or braze to hot or cold
water connections. If sweat connections are
used, sweat tubing to adapter before installing
the adapter to the hot or cold water
connections on heater. Any heat applied to the
water supply fittings will permanently damage
the internal plastic lining in these ports.
* The maximum pressure in cold water supply
line is 0.8 MPa. If the supply water is greater
than 0.8 MPa, install a pressure reducing valve.
* Connect the water for filling or refilling the
heating system as specified by EN1717/ EN
61770 to avoid contamination of drinking
water by return flow.
Maximum and minimum water
operating temperatures (°C)
Maximum and minimum water
operating pressure (MPa)
Refer to "Installation Instructions" for
suggested typical installation.
1
Check the type of water pipes in your
home. Use fittings adequate for the type of
pipe in your home.
If cooper piping used, The water heater
should always be connected dielectric
connections (filed supply) to avoid corrosion
caused by electric currents common in
copper water pipes.
For ease of disconnecting the water heater
for service or replacement, the installation
of unions is recommended on the water
connections.
2
Apply Teflon tape on the G end to prevent
leaking.
3
Connect cold and hot water supply using
3/4" G.
4
Install a shut-off valve in the cold water
line near the water heater.
5
Install the insulation on the cold and hot
water pipes. Insulating hot water pipe can
increase energy efficiency.
To Fill the Water Heater
35 / 62
- / 0.8 WARNING
!
Do not turn on the electrical power to
water heater unless the tank is
completely full of water. The water
heater warranty does not cover damage
or failure resulting from operation with
empty or partially empty tank.
1
Make sure that the drain valve on water
heater is completely closed.
2
Turn on the cold water supply
3
Open each hot water faucet slowly and
allow the water to run until it flows with a
full stream.
4
Let the water run full stream for a few
minutes.
EN
19