Error Codes And Flashing Sequences - HomeMatic IP HmIP-BROLL-2 Installations- Und Bedienungsanleitung

Troubleshooting
To be able to use the device again, you must remove the
overload and disconnect the device from the voltage
supply and connect it again. Alternatively, you can wait
30 minutes after removing the overload („automatic re-
set"). The device can then be restarted again. The device
is not switched on automatically after the end of the au-
tomatic reset.
8.4

Error codes and flashing sequences

Flashing code
Short orange
flashing
1x long green
lighting
Short orange
flashing (every
10 s)
50
Meaning
Radio
transmission/
attempting to
transmit/data
transmission
Transmission
confirmed
Pairing mode
active
Solution
Wait until the
transmission is
completed.
You can continue
operation.
Please enter the last
four numbers of the
device serial number
to confirm (see „6.3
Add device" on page
46).