HomeMatic IP HmIP-BROLL-2 Installations- Und Bedienungsanleitung Seite 47

To integrate the Shutter Actuator into your system and
enable it to communicate with other Homematic IP
devices, you must add the device to your Homematic IP
Access Point first.
To add the Shutter Actuator, please proceed as follows:
• Open the Homematic IP app on your smart-
phone.
Select the menu item "Add device".
•
• After installation, the pairing mode of the device
remains activated for 3 minutes.
If the time has exceeded, you can manually re-
start the pairing mode for another 3 minutes by
removing the rocker and pressing the system
button (A) shortly (see figure 9).
• Your device will automatically appear in the
Homematic IP app.
• To confirm, please enter the last four digits of the
device number (SGTIN) in your app or scan the
QR code. Therefore, please see the sticker sup-
plied or attached to the device.
• Please wait until pairing is completed.
If pairing was successful, the LED (A) lights up
•
green. The device is now ready for use.
• If the LED lights up red, please try again.
• Complete the setup of your Shutter Actuator by
following the instructions in the app.
Start-up
47