Hisense RT641N4WFE1 Bedienungsanleitung Seite 45

Note: If required, you may lay the refrigerator
on its back in order to gain access to the
base, you should rest it on soft foam
packaging or similar material to avoid
damaging the backboard of the refrigerator.
To reverse the door, the following steps
generally recommended.
1. Stand the refrigerator upright. Open the
door to take out all door racks (to avoid
damage) and then close the door.
Caution!
Please slightly squeeze the door rack from
one side toward center, and then move it
upward when taking out the door racks.
Remove screw①, then take down
2.
cover② from the top right side. Be
careful of the electrical connector③
below, because it's still connected. Then
unconnect it and remove cover②.
①
Self-tapping screw
②
Upper hinge cover
①
②
③
3.Press the door switch④ ,then remove it
upward. Install switch④ into cover⑤
(provided in the plastic
other cover② into the plastic bag.
④
15
③
Eletrical connector
④
Door switch
③
④
bag). Put the
⑤ Upper hinge
cover-left
4.Unscrew screws① by a 8mm socket
driver or a spanner, and remove hinge②.
Then put the conector③ into the hole.
Please hold the door by hand when
installing.
①
Special flange screw
②
Upper hinge
③
Electrical connector
5.Remove the upper door from the
middle hinge by carefully lifting the door
straight up. Then Place the upper door
on a smooth surface with its upper cover
upwards.
6.Install cover① (provide in the plastic
bag) on the top right side.Then remove
cover② from top left side of the
appliance, and put it into the plastic bag.
① Screw hole
cover-right
Loose screw③ and take down part②
7.
and part ①, Install replacement door
stopper-left④ and stop block-left⑤
(provided in the plastic bag) to the left
side with screw③. Keep part ① and
part② with the appliance for future
reference.
④
⑤
①
②
③
② Screw hole
cover-left
① Door stopper
② Stop block
③ Self-tapping screw
①
②
③
Door stopper-left
④
⑤ stop block-left