Preparation For Use; Instructions For Use; Maintenance - eta CRUX Bedienungsanleitung

EN
III. PREPARATION FOR USE
After the first putting into operation and let an „open" toaster in operation with a window
open for about 10 minutes, then turn it off and let it cool down. After the appliance cools
down, swipe the parts that come in contact with food with a soft, wet and clean cloth or
a paper towel.
IV. INSTRUCTIONS FOR USE
Plug the power cord connector A6 to an electric socket and make sure the power cord is not
damaged, it goes under the toaster or through any sharp or hot surfaces. A red signaling light
A2 will come on, signaling connection to electric power supply. The plates will start to heat.
When the operating temperature is reached, the green signaling light A2 will come ON. When
the appliance is used for the first time, short and slight smoke may occur which does not mean
any defect. Open the lock A4 and lift off the lid A1 using the handle A3. Put the prepared
food on the bottom plate A5, close the lid and secure it with the lock A4. Do not close the lid
by excessive force! During preparation of food, the green signaling light will come on and
off which means that the thermostat keeps the proper temperature. When the preparation is
complete, open the lid and remove the food (using e.g. a wooden spatula). Do not use sharp
metal tools to take the food out (e.g. pliers, turners, a knife or other sharp metal kitchenware),
it could damage the non-stick surface finish of the grilling plates. Never cut the prepared food
on the plates!
• Always let the plates A5 heat up to the operating temperature before putting food
in. When heating the plates, keep the lid closed. Do not touch the plates as they
are HOT! Be specially careful and prevent children and incapable persons from
touching the plates!
• We recommend using personal protective aids (e.g. kitchen glove) when handling.
V. MAINTENANCE
Unplug the appliance from power supply by taking the plug of the power cord out
of the socket! Clean the toaster only when it has cooled down! Clean the appliance
regularly after each use. Do not use rough and aggressive detergents (e.g. sharp objects,
peelers, caustic agents for cleaning ovens, or other solvents). For cleaning the cover,
use detergents for cleaning plastic (stainless steel) surfaces. Clean the surface by wiping
it with a soft and wet cloth. Before every other use, dry all parts and surface of the toaster
thoroughly. If the power cord is soiled, wipe it with a wet cloth. It is normal that the surface
colour changes over the time. But the change does not alter the surface properties in any
way and the appliance is not subject to a complaint for this reason!
More extensive maintenance or maintenance requiring intervention in the inner parts
of the appliance must be carried out by professional service! Failure to comply with
the instructions of the manufacturer will lead to expiration of the right to guarantee
repair!
Note
EN - 16