Werbung
Start up
Caution
Dry runs lasting longer than two minutes lead to
damages to the high pressure pump. If the appli-
ance does not build up pressure within two min-
utes, switch it off and proceed as instructed in
the Chapter "Troubleshooting".
Connect the high pressure hose to the high
pressure connection of the appliance.
Push the spray lance into the trigger gun and
fasten it by turning it through 90°.
Completely open the water tap.
Insert the mains plug into the socket.
Turn on the appliance "I/ON".
Operation
Danger
The trigger gun is subjected to a recoil force
when the water jet is discharged. Make sure that
you have a firm footing and are also holding the
trigger gun and spray lance firmly.
Unlock the lever on the trigger gun.
Pull on the lever of the trigger gun; the device
will switch on.
Note: Release the lever of the trigger gun; the
device will switch off again. High pressure re-
mains in the system.
Spray lance with Dirtblaster
For particularly dirty items or areas.
Not suitable for use with detergents.
Spray lance with high pressure nozzle
For normal cleaning tasks.
Not suitable for use with detergents.
Working with detergent
Please use exclusively KÄRCHER detergents
and care products to carry out the respective
cleaning task, as these were specifically devel-
opped for your appliance. The use of other deter-
gents and care products may lead to premature
wear and can invalidate your warranty claims.
Please obtain information at your local dealer or
request information directly from KÄRCHER.
Detach spray lance from the trigger gun.
Work only with the trigger gun.
Suspend end of detergent suction hose in a
container filled with detergent.
Recommended cleaning method
Spray the detergent sparingly on the dry sur-
face and allow it to react, but not to dry.
Spray off loosened dirt with the high-pres-
sure jet.
Interrupting operation
Release the lever on the trigger gun.
Lock the lever on the trigger gun.
During longer breaks (more than 5 minutes),
also turn the appliance off using the "0/OFF"
switch.
Insert the trigger gun in its holder.
Finish operation
Caution
Only separate the high-pressure hose from the
trigger gun or the appliance while there is no
pressure in the system.
After working with detergent, suspend deter-
gent suction hose in a container filled with clear
water, switch the appliance on for around 1
minute once the spray lance has been re-
moved and rinse until water runs clear.
Release the lever on the trigger gun.
Turn off the appliance "0/OFF".
Turn off tap.
Detach the appliance from the water supply.
Press the lever on the trigger gun to release
any remaining pressure in the system.
Lock the lever on the trigger gun.
Pull out the mains plug.
Stow away the mains cable, the high-pres-
sure hose and accessory at the appliance.
Caution
In order to prevent accidents or injuries, keep in
mind the weight of the appliance during transport
(see Specifications).
When transporting by hand
Lift appliance by the carrying handle and carry it.
When transporting in vehicles
Secure the appliance against shifting and
tipping over.
Caution
In order to prevent accidents or injuries, keep in
mind the weight of the appliance when selecting
a storage location for it (see Specifications).
– 6
EN
Transport
Storage
13
Werbung
