Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
5.2 Cleaning cycle
If necessary, you can activate the cleaning cycle, which filters the water after using the hot tub. To do it,
simply press the pump on/off button to leave the AUTO mode and activate the pump. The pump will run for
POOL EQUIPMENT
KLIN GOTHIC ITC DEMI-13,3 b
a fixed period of time (90 minutes), and the water will circulate through the filter cartridges. The system then
reverts to the AUTO mode and maintains the water temperature ready for the next use of the hot tub. Press
the pump 1 speed change button
Comments:
zlatá
1. The heating will start and stop as needed whenever pump 1 is running in either the PUMP AUTO or
černá
PUMP ON mode.
2. The PUMP AUTO mode will be activated after 90 minutes while the control panel is not activated, as long
as it is left in the PUMP ON or PUMP OFF mode.
6. Auxiliary equipment (AUX)
Pressing the AUX button twice controls the equipment functioning as follows:
First pressing (auxiliary equipment on)
the display reads „Aux on"; the button diode shines green
Second pressing (auxiliary equipment off)
the display reads „Aux off"; the button diode is off
Comments:
If the auxiliary equipment is left on, it turns off automatically after 25 minutes.
1. If the heater is on, the operation of this equipment may cause the heater to load the disconnector and
switch off.
2. If this happens, the heater will resume operation about 5 seconds after the „Aux" mode is deactivated.
to enter PUMP LOW, and the 90-minute cleaning cycle starts.
PANTONE 871 U
PANTONE 426 U
on/off (Pump 2)
8
Werbung
