Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Values recommended by the manufacturer: TA up to 125 ppm, CH up to 150 ppm, and pH 7.0-7.6. Under
normal European circumstances, water for the common user will have been treated by the water utility that
delivers it through the mains, so the alkalinity and calcium hardness are usually within the required limits.
POOL EQUIPMENT
KLIN GOTHIC ITC DEMI-13,3 b
Yet it may be the case that the pH is not within our recommended range, that is pH 7.0-7.6. In most cases,
the pH will be above the recommended range. To reduce the pH, you can use a chemical preparation known
as pH-. Practical tip: We advise you carry out any measurements of water quality in the spa after the normal
filtration and water cleaning cycle has ended (at least 2 hours) - never make any measurements immediately
after using the hot tub. If you test the water quality immediately „after a bath", the pH and other values will
zlatá
be markedly distorted.
černá
4. Programme the hot tub control unit using the control display
If everything is in order, you can start programming the hot tub control unit. After programming, cover
the hot tub and allow its temperature to stabilise. Check the water level in the hot tub periodically.
14. Caring for your hot tub
General information
If the hot tub is in the exterior, we advise you prevent direct sunlight from acting upon the hot tub by, e.g.,
installing the hot tub under a pergola. Under no circumstances should you expose the hot tub to direct
sunlight if it is waterless. Use the thermal cover for this purpose; it may have been supplied with your tub.
The procedure for shutting down the hot tub, especially in winter, is described in Chapter 12, Winter and
summer use.
Operating rules
The hot tub is not designed for commercial use. Under no circumstances is it permissible that the pump be
activated without a sufficient water level in the hot tub. The water level must be kept at the indicated height.
The user is not allowed to generate overpressure or negative pressure in the equipment by blocking the jets
or the skimmer while the pump(s) is/are running, provided the hot tub has any. It is also impermissible to
shut valves in the circuit, etc. Prevent foreign objects from entering the skimmer suction area. Make yourself
thoroughly familiar with the Operating Instructions before first use. Always have the Instructions within easy
reach. The manufacturer has introduced the client to the technical parameters of the hot tub and pointed out
its advantages and drawbacks. Under certain circumstances, water aeration may alter slightly in hot tubs - in
the circulation jets.
1. No unqualified interference with the hot tub equipment and wiring is permissible. Please contact
a professional service provider in the event of any defect. Unqualified interference with the above may
result in injury and loss of warranty.
2. Maintain overall spa cleanness periodically. The frequency of cleaning the hot tub depends on the frequency
of using the spa.
3. Perform cleaning of the filter cartridges depending on the frequency of your use of the hot tub.
14.1 Filtration cartridges (installation, removal, maintenance)
Remove any packaging off the cartridges before installing them. Push the suction (skimmer) housing
upwards. Remove the rough dirt basket. The suction area has two holes with a threaded section (thread)
in the suction bottom. The cartridge has a thread at the bottom too. Screw the cartridge into the threaded
suction part, clockwise, and tighten it gently. Reverse the installation procedure for replacing the cartridges.
PANTONE 871 U
PANTONE 426 U
37
EN
Werbung
