Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
16. Troubleshooting
POOL EQUIPMENT
Problem
KLIN GOTHIC ITC DEMI-13,3 b
Turbid water
zlatá
černá
Water odour
Chlorine odour
Musty odour
Organic sediment/circle
of scum around the spa
Algal growth
Reduced transparency
Limescale
Hot tub does not work
as a whole
The hot tub does not
warm up and the light
is on (readiness and
power indicators blinking).
Reduced pump performance.
Light not on.
Likely causes
Dirty filters
Neglected hygiene
Dispersed particles / organic substances
Water used for too long
PANTONE 871 U
PANTONE 426 U
Too many organic substances in the water.
Neglected hygiene.
pH too low.
Too much free chlorine.
pH too low.
Bacteria or algae propagating.
Deposition of oils and dirt.
pH too high.
Too little disinfectant.
pH too low.
Too little disinfectant.
Too much calcium in the water;
too much total alkalinity and pH too high.
Water level too low.
Power supply failure.
Heater off.
Water level too low.
Security thermostat off.
Integrated pressure switch interrupted.
Circulation pump thermal trip off.
Dirty filters.
Water level too low.
Dirty filters.
Air controls shut.
Faulty wiring or light assembly.
Clean the filters.
Treat the spa with a disinfectant.
Add disinfectant.
Adjust the pH and/or alkalinity as recommended.
Turn on the massage pumps and clean the filters.
Drain the spa and refill it.
Treat the spa with a disinfectant.
Add disinfectant.
Adjust the pH, then refill the spa.
Replace 1/3 of the spa water.
Adjust the pH as recommended.
Treat the spa with a disinfectant.
If the problem is visible or lasting, drain the spa,
clean it and refill it.
Wipe the spa with a clean cloth. If there is too much
scum, drain the spa. Remove the scum with
a detergent and refill the spa. Treat the spa with
a disinfectant and adjust the pH.
Treat the spa with a disinfectant and keep
its concentration.
Adjust the pH.
Treat the spa with a disinfectant and keep
its concentration.
If scale needs removing, drain the spa, remove
the scale, refill the spa
and balance the water composition.
Add water. Check the power supply. Restart the
heater. Disconnect the power supply for at least
30 seconds for the security thermostat to restart.
If reset is impossible, check the filters for clogging.
If the hot tub keeps switching off, call maintenance.
Check the filters. The integrated pressure switch
restarts when water flow through the heater
is restored. Call maintenance if the heater switches
off too often. Checks the filters and piping leaks.
Disconnect the hot tub from the power supply and
allow the circulation pump to cool down.
The circulation pump thermal trip restarts when
the pump cools down and the power supply
is reactivated.
Call maintenance if the circulation pump
thermal trip switches off too often.
Add water.
Clean the filters.
Open the air controller.
Call maintenance.
40
Solution
Werbung
