Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
2. Exterior hot tub installation
If installing the hot tub in the exterior, make sure you observe the safety precautions. The chief requirements
for safe hot tub operation include non-slip tiling (flooring), and a drained installation site for the event of rain
POOL EQUIPMENT
KLIN GOTHIC ITC DEMI-13,3 b
or water pouring or spillage over the hot tub rim. For these reasons, you are advised to adjust the installation
site to these requirements.
Preparation for the power connection
For connection to three-phase alternating current, make sure you use a 16 A circuit breaker with characteristic
zlatá
C. Make sure that the hot tub is always connected to a circuit protected with an earth-leakage trip with
černá
a residual current of 0.03 A. If a fuse has to be replaced, always use a fuse of the same type and rated current.
Hot tub installation
Note: The hot tub has to be located in accordance with standards in force in your country; in the Czech
Republic it is ČSN 33 2000-7-701.
General: You are advised to take advantage of the professional services of qualified and trained technicians
for the installation, power connection and first startup. If you decide to install the hot tub by your own
devices, please follow the advice below.
1. Carefully remove all the packaging in which the hot tub was delivered, and position the hot tub on
the pre-rendered installation site.
2. Remove the front panel, situated at the side of the hot tub control panel. Remove the upper power
switchboard cover, under which the circuit breaker, the earth-leakage trip and earth connector are situated.
The connection using the appropriate power cord may only be performed by a person with professional
qualifications.
3. Since your hot tub was thoroughly tested during the manufacturing process, meaning some proportion of
impurities may have remained in the hot tub equipment parts and on its surface, you are advised to first
clean the hot tub surface in an appropriate way. We recommend using lukewarm water for this cleaning.
As a rule, clean the surface using suitable soft towels; avoid using any coarse abrasives and fabrics, which
might cause damage to the spa surfaces. If you choose to use any detergent, make sure it is not aggressive
to the spa surfaces.
1. Filling the hot tub with water
Fill the hot tub with a sufficient amount of water. The water level in the hot tub may never decrease below
the skimmer level. If you detect any water leakage when filling the hot tub, interrupt the filling until
the defect is eliminated.
2. Activating the power supply for the hot tub
If the hot tub is connected via a flexible cord, the power cord must not be exposed to any burdening with
sharp objects or other effects. If that is the case, we advise you lay the power cord inside a protective sleeve.
Switch on the circuit breaker reserved for the hot tub.
3. Rules for hot tub water quality maintenance
Several rules have to be followed to ensure the trouble-free operation of your hot tub. One of these rules
is to periodically replace the entire bulk of water in the spa. We recommend changing the water at least
once every 3 months, with respect to the frequency of operation and use of the hot tub. Spa water quality is
best determined using testers, which can be obtained from your retailer. The tester allows you to measure
(analyse) the total alkalinity (TA), calcium hardness (CH) and pH; these values have to be maintained.
PANTONE 871 U
PANTONE 426 U
36
Werbung
