Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
Press 5 times
The LCD reads „BURST UP/DOWN"; the light colours alternate one by one. Very similar setting, FADE
UP/DOWN, only the colour appears very fast and fades slowly. Use the UP and DOWN buttons to change
POOL EQUIPMENT
KLIN GOTHIC ITC DEMI-13,3 b
the speed of light effect alternations (see chapter 8.2.1 below).
Press 6 times
The LCD reads „DELAYED CHANGE"; the light colours alternate one by one. Each colour is shown for
a short while, then the light switches to the next colour quickly. Use the UP and DOWN buttons to change
zlatá
the speed of light effect alternations (see chapter 8.2.1 below).
černá
Press 7 times
The LCD reads „STEP CHANGE"; the light colours alternate one by one. Use the UP and DOWN buttons
to change the speed of light effect alternations (see chapter 8.2.1 below).
This setting is saved and will be restored automatically when you turn the light on again.
8.2.1 Light effect mode speed settings
Once you have selected a light effect mode („SMOOTH CHANGE" to „STEP CHANGE"; see above),
you can manually adjust the speed at which the available colours alternate. When the UP/DOWN buttons are
pressed for the first time, the LCD reads „EFFECT SPEED" with a bar chart depicting the current setting.
In this display, press UP and DOWN to adjust the cycle speed as needed. Hold one of the buttons down to
automatically repeat the pressing. In the highest setting, 100%, the speed is about 40 times faster than in
the lowest, 2%, and about 6 times faster than in the default setting, 50%. The settings for each light effect is
saved separately and will be restored the next time you choose the light effect mode.
DOWN and UP
Comments:
1. The UP and DOWN buttons are shared by the Light, Light Change, SPVSB Blower Speed, and the entire
system menu. While not in the system menu, the current function of the UP and DOWN buttons depends
on which of the 3 features was last adjusted by the button, whether Light, Light Change or Blower.
2. Pressing either LIGHT or Light Change when the light is on will only browse through the available
options; the LCD will show the current option/selection. This makes it possible to set the function for
the UP and DOWN buttons and display the current Light or Light Change setting without actually
changing the setting.
3. Pressing Light Change when the light is off will switch the light on using the Light High setting.
4. As the default, the control panel backlighting reflects the spa setting, but this feature can be deactivated.
See chapter 9.9.5.
PANTONE 871 U
PANTONE 426 U
36,75
°C
EFFECT SPEED:
100%
12
Werbung
