Ikra IPM 33 TL Gebrauchsanweisung Seite 67

- Mount the bar (4) by inserting the stud bolt (3) in the
groove and push it towards the back of the starter unit
- Mount the chain in the right direction around the drive
sprocket and along the bar rail (Fig. 3). If the tip of the
bar has a nose sprocket, make sure the drive links fit
correctly in the sprocket rims.
- Check that the chain tension adjuster pin (5) is fitted
properly in the hole on the bar; if it isn't, turn the chain
tension adjuster screw (6) using a screwdriver until the
pin is completely inserted.
- Fit the guard (2) back on without tightening the nut (1).
- Turn the chain tension adjuster screw (6) to adjust the
chain tension.
- Raise the bar (4) and tighten the nut (1) on the guard
(2) securely using the wrench.
GB-23