Operating Menu "Maintenance; Operating Menu "Addresses; 6.10 Key "Slideshow; Operating Menu "Keypad Settings - Honeywell 013002 Bedienungsanleitung

26
6.8 Operating menu
"Maintenance"
The key "Maintenance" opens the operating
menu for displaying versions, for input of the
next maintenance date and for enabling/
disabling remote parameterization.
Use the key "Version" to open the display of the
software-versions of the central control panel
and the Touch operating module. Additionally
the menu shows all available and all used
ROM- and RAM memory values.
Use the key " " to switch back to operating
menu "Selection".
6.9

Operating menu "Addresses"

The key "Addresses" opens the operating
menu for displaying stored address infor-
mations.
Use the key " " to switch back to operating
menu "Selection".

6.10 Key "Slideshow"

The key "Slideshow" starts the slideshow.
Information on the slideshow settings and the
slideshow time settings can be found in the
chapters "Slideshow settings" and "Slideshow
time settings".
6.11 Operating menu
"Keypad settings"
The key "Keypad settings" opens the operating
menu for adjusting of the display contrast and
the keypad tone volume.
Move the slide control by means of the finger to
the desired value and acknowledge the
selection with the key "Apply".
Only the keypad tone volume is setted.
Adjusting of the alarm buzzer is not
possible.
Use the key " " to switch back to operating
menu "Selection".
Operating Manual Touch operating module for MB/MB-Secure
Next maintenance
00.00.00
Remote parameterization
disabled
Maintenance
Keypad settings...
Screen brightness
Keypad tone volume
Apply
Version
Enable remote
parameterization
Cancel